(FS22, not FS25) Issue with workers deviating from the course set.

[Nthenrique]

Version

8.0.0.0

SP/MP

SP (Singleplayer)

What is your question about?

Global CP settings

What is your question?

Hello everyone.

I'm having this veering off course issue in some fields (flat or hills, doesn't matter). The tractor (wheels or tracks, both do it) get in the correct line, put the tool in the ground and activate it correctly, and after a few meters it starts veering off course, with the tool in the ground and active (planter, cultivator etc)
Some will go straight and will hit the edge of the map, some will do a huge loop and get back to the same spot, back to the course it was following, and act normal again.

• Is there a setting in the menu I should change to reduce the chances or avoid this from happening?

• Courseplay v. 7.5.0.1 for Farm Simulator 2022 (singleplayer)

• CP Pathfinder: Angle set to 45 and Delta set to 20

• CP Vehicle: all default, except raise and lower tools (inverted), and only turning on field (disabled)

• • The "Allow using the pathfinder in turns" default setting is disabled, i have turned it on only a few minutes ago to test it. It's veering with it disabled by default

• Map: Hubbard 16X (8x8km). Field 125 (101 acres).

Screenshots

[Nthenrique]

The "Allow using the pathfinder in turns" default setting is disabled, i have turned it on only a few minutes ago to test it. It's veering with it disabled by default