- Control happens over the Dante Primary port
- Default IP address: 192.168.02
- Use Provisionair Designer to build your processor file
- Use Provisionair Controller to build a control interface
- Use Provisionair Kiosk to run your control interface
- ohmygod Yamaha, what if it wasn't 3 pieces of software?!
- Pay very close attention when you're syncing to the processor
- Unless you're updating a change in your project file, you really should be syncing from device to computer
- save often!
- Pray that you have a recent save of the project file AND your Dante patch
- Unplug the processor from the Dante network and follow instructions to initialize it:
- (this is where I'll put those instructions)
- After you initialize the processor, connect your control computer directly to the Dante Primary port on the back of the processor
- Establish a connection using Provisionair Designer and your project file
- Sync from computer to device
- Pray a second time
- Maybe try a diety that you haven't prayed to before
- If all seems happy, disconnect the control computer from the processor, and then put the processor back on the Dante network
- Load a saved Dante preset for the processor
- Initializing the processor breaks Dante subscriptions, so you'll need to go through an re-sibscribe
- put meters on your inputs and outputs - this is going to help you later on when trying to troubleshoot signal flow
- you can then also put these into the visual/control layout for Provisionaire Control/Kiosk