Danfoss ECL Modbus Integration for Home Assistant

This is a custom integration for Home Assistant to control Danfoss ECL Modbus devices.

Installation

1. Install via HACS.
2. Restart Home Assistant.
3. Add the "Danfoss ECL Modbus" integration in Home Assistant.

Configuration

The integration is configured via the Home Assistant UI. You will need to provide the following information:

• Host: The IP address of your Danfoss ECL Modbus device.
• Port: The port number of your Danfoss ECL Modbus device (default is 502).
• Slave: The slave ID of your Danfoss ECL Modbus device (default is 5).

Supported Entities

This integration supports the following entities:

• Climate: ECL Värme
• Sensor: ECL Actual Mode, ECL Outside Temp, ECL Addition Temp
• Switch: ECL Pump Switch
• Binary Sensor: ECL Pump